Filter
Top Products
Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. H • 6/07
35
Installing the Trim
Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 149° C minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between
combustible material (sheetrock or wood) and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.
!
Step 10. Installing Trim, Logs & Ember Material
Figure 32. Lower Door Assembly
Attachment of Lower Door Assembly
This unit is shipped with the door stops unattached to assist
in the set-up of the unit. After the gas and electrical have
been run, the door stops can be used if desired as shown
in Figure 32.
SHOULDER
BOLT
LOWER
DOOR
SHOULDER
BOLT
DOOR
STOPS
DOOR
STOPS
!
WARNING: CHILDREN AND ADULTS SHOULD
BE ALERTED TO THE HAZARDS OF HIGH
TEMPERATURES OF WORKING SURFACES ON
THESE HEATERS. WORKING SURFACES INCLUDE
ALL GLASS PANELS AND DECORATIVE DOORS.
YOUNG CHILDREN SHOULD BE CAREFULLY
SUPERVISED WHEN THEY ARE IN THE SAME
ROOM AS THE APPLIANCE.
Log placement
CAUTION: Logs are fragile. Carefully remove the logs from the packaging. Logs #4 and #5 are the same log.
See Service Parts pages for individual assembly photos.
Log Set Assembly: LOGS-ST-CE
Only for Models: ST-HVB-CE, PIER-HVB-CE and RCOR-HVB-CE
1
2
3
4
5
6
TABS