Filter
Top Products
26678 Rev H 2 02-02
GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT
CAUTION:
Do not expose the appliance to the elements (such as rain, etc.)
SAFETY PRECAUTIONS
1. Please read these installation instructions completely
before beginning installation procedures. Failure to
follow them could cause a malfunction resulting in
serious injury and/or property damage.
2. Installation and repair should be done by a qualified
service person. This appliance should also be
inspected annually by a qualified service person. More
frequent inspections/cleaning may be required due
to excessive lint from carpeting, bedding material, etc.
It is imperative that the control compartment and
burners of the appliance be kept clean.
3. The GBi25is a vented gas appliance. Do not burn
wood or other material in this appliance.
4. NEVER leave children unattended when there is a
fire burning in the fireplace.
5. This appliance must be vented with a minimum 4 B-
Vent system and must terminate above the roof line.
Venting must not be connected to a chimney flue
servicing a solid fuel burning appliance.
6. Use only the fuel gas specified on the rating label of
this gas appliance.
7. The appliance area shall be kept clear and free from
combustible materials, gasoline and other flammable
vapors and liquids.
8. While servicing this appliance, always shut off all
electricity and gas to the appliance. This will prevent
possible electrical shock or burns. Also, make sure
the fireplace is completely cooled before servicing.
9. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
10. Be sure to provide adequate clearances around the
air openings into the combustion chamber and
adequate accessibility clearances for servicing and
proper operation.
11. Provisions shall be made to provide adequate
combustion and ventilation air. The flow of combustion
and ventilation air should not be obstructed.
Contents
A. Listings and Code Aprovals .....................................................................................................3
B. Description of the System ....................................................................................................... 3
C. System components ............................................................................................................... 4
D. Dimensions and Clearances ................................................................................................... 4
E. Pre-Installation Preparation .....................................................................................................5
F. Step-by-Step Installation of the System ...................................................................................6
G. Operating Instructions ...........................................................................................................14
H. Maintenance Instructions ....................................................................................................... 16
I. Troubleshooting .....................................................................................................................17
J. Replacement Parts ...............................................................................................................18
K. Optional Components ...........................................................................................................19
Index ......................................................................................................................................23
Warranty ................................................................................................................................24