Filter
Top Products
Heatilator • Novus NDV Series • 4055-187 Rev. V • 1/12 71
13 in.
(330 mm)
15 in.
(381 mm)
8-1/8 in.
(206 mm)
SLP-HRC-SS
10-7/8 in.
276 mm
10-1/2 in.
267 mm
3°
87°
Effective Length
5-3/4 to 8-3/8 in.
146 to 213 mm
5-1/2 in.
140 mm
8-3/8 in.
213 mm
SLP-HRC-ZC-SS
(Not approved for NDV4842)
(Not approved for NDV4842)
B. Vent Components Diagrams (continued)
Figure 17.9 SLP Series Vent Components
SLP-TRAP
Horizontal Termination Cap
15-1/8 in.
(384 mm)
12 in.
(305 mm)
8 in.
(203 mm)
Max
Effective
Length
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm) the
existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a DVP-HSM-B
will be required.
Heat
Shield
Term Cap
Minimum
Effective Length
Maximum
Effective Length
Trap1
3 1/8 in. 4 3/4 in.
79 mm 121 mm
Trap2
5 1/4 in. 9 1/4 in.
133 mm 235 mm
PVK-80
(For use with IPI and DSI appliances only.)
11-1/2 in.
(280 mm)
12-1/2 in.
(317 mm)
16 in.
(406 mm)
9 in.
(229 mm)
2-3/4 in.
(70 mm)
12-1/4 in.
(311 mm)