Filter
Top Products
Heatilator • Novus NDV Series • 4055-187 Rev. V • 1/12 3
Safety Alert Key:
• DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury.
• WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury.
• CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
• NOTICE: Used to address practices not related to personal injury.
Table of Contents
A. Congratulations 2
B. Limited Lifetime Warranty 5
1 Listing and Code Approvals
A. Appliance Certifi cation 7
B. Tempered Glass Specifi cations 7
C. BTU Specifi cations 7
D. High Altitude Installations 7
E. Non-Combustible Materials Specifi cation 7
F. Combustible Materials Specifi cation 7
G. Electrical Codes 7
H. Requirements for the Commonwealth
of Massachusetts 8
User Guide
2 Operating Instructions
A. Gas Fireplace Safety 9
B. Your Fireplace 9
C. Fan Kit (optional) 10
D. Clear Space 10
E. Decorative Doors and Fronts 10
F. Fixed Glass Assembly 10
G. Remote Controls, Wall Controls and Wall
Switches 10
H. Before Lighting Fireplace 10
I. Lighting Instructions (IPI) 11
J. Lighting Instructions (Standing Pilot) 12
K. After Appliance is Lit 13
L. Flame Adjustment Control 13
M. Frequently Asked Questions 13
3 Maintenance and Service
A. Maintenance Tasks-Homeowner 14
B. Maintenance Tasks-Service Technician 15
Installer Guide
4 Getting Started
A. Typical Appliance System 17
B. Design and Installation Considerations 18
C. Tools and Supplies Needed 18
D. Inspect Appliance and Components 18
5 Framing and Clearances
A. Select Appliance Location 19
B. Constructing the Appliance Chase 20
C. Clearances 20
D. Mantel and Wall Projections 21
6 Termination Locations
A. Vent Termination Minimum Clearances 22
7 Vent Information and Diagrams
A. Approved Pipe 24
B. Vent Table Key 24
C. Use of Elbows 24
D. Measuring Standards 24
E. Vent Diagrams 25
8 Vent Clearances and Framing
A. Pipe Clearances to Combustibles 34
B. Wall Penetration Framing 34
C. Install the Ceiling Firestop 35
D. Install Attic Insulation Shield 36
9 Appliance Preparation
A. Top Vent 37
B. Rear Vent 38
C. Secure and Level the Appliance 39
10 Installing Vent Pipe
A. Assemble Vent Sections (DVP only) 40
B. Assemble Vent Sections (SLP Pipe Only) 41
C. Assemble Slip Sections 41
D. Secure the Vent Sections 42
E. Disassemble Vent Sections 42
F. Install Decorative Ceiling Components (SLP only) 43
G. Install Metal Roof Flashing 44
H. Assemble and Install Storm Collar 44
I. Install Vertical Termination Cap 45
J. Install Decorative Wall Components SLP only) 45
K. Heat Shield Requirements for Horizontal
Termination 45
11 Shrouds
A. HHT Shrouds 47
B. Field Constructed Shrouds 47
12 Gas Information
A. Fuel Conversion 49
B. Gas Pressure 49
C. Gas Connection 49
D. High Altitude Installations 49
13 Electrical Information
A. Wiring Requirements 50
B. Standing Pilot Ignition System Wiring 50
C. Intellifi re Ignition System Wiring 50
D. Optional Accessories Requirements 50
E. Electrical Service and Repair 51
F. Junction Box Installation 52
G. Wall Switch Installation for Fan (Optional) 52
14 Finishing
A. Mantel and Wall Projections 53
B. Facing Material 54