Filter
Top Products
Heatilator • Novus NDV Series • 4055-187 Rev. V • 1/12 55
15
15
Appliance Setup
A. Remove the Packaging
Remove the shrink fi lm, corrugated top cap, bottom cap
and column protectors from the appliance. The appliance
should look as shown in Figure 15.1.
B. Remove Screen Package Assembly
• Grasp the top of the screen package and lift up to remove.
See Figures 15.2 and 15.3.
C. Remove the Shipping Materials
Remove the shipping materials from inside or underneath
the fi rebox.
E. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
Figure 15.1 Appliance Unwrapped
F. Accessories
Install approved accessories per instructions included
with the accessories. Refer to Section 17.
WARNING! Rick of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
Figure 15.2 Lift up on Screen Package
Figure 15.3 Remove Screen Package
Latches
(both bottom
and top)
Glass
Assembly
Figure 15.4 Glass Assembly
D. Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
DO NOT:
• Strike, slam or scratch glass
• Operate fi replace with glass removed, cracked,
broken or scratched.
Replace fi xed glass assembly as a complete assembly.
• Remove screen.
• Pull the four (30/33/36 in. appliances) or seven (42 in.
appliance) glass assembly latches out of the groove on
the glass frame. Refer to Figure 15.4.
• Remove the glass assembly from the appliance.