Filter
Top Products
33
THERMOSTAT INSTALLATION
9 The MagnuM Countryside can be installed with and operated by a wall-
mounted thermostat. However, a wall thermostat is not provided with the
stove. A wall thermostat can be purchased from your reseller or at most
home improvement centers or hardware stores. The wall thermostat needs
to be for a low voltage system. Most thermostats will have instructions
with them as to where to place them in your room. Please follow the
thermostat manufacturer’s instructions carefully.
9 There are two (2) male spade terminals on the back of the control panel near
the center. Connect the two wires from the wall thermostat, one to each of
these spade terminals. Needed: 2 female ¼” insulated terminals.
9 Make sure that the wires are routed to protect them from hot surfaces. Do
not cross wires with circuitry on board.
9 The circuit board is located on the left side of the unit. Remove the ¼” hex
head screw and pull circuit board towards you. Lift the circuit board out of
the housing. Do not crimp or stretch the wires leading from circuit board
pigtail. (Unplug the power cord before working on unit)
9 Reinstall in reverse procedure.
Two (2) ¼” male spade
connectors, one for each
wire from wall thermostat
It is a good idea to use the thermostat option to achieve uniform control over your heating needs. By
setting the unit on a number 3 setting (this is the normal setting but can be any setting from 2-high) for
high fire and letting the wall thermostat control it, the fire will drop down into a pilot fire after the home
reaches the desired temperature.
If you are gone and the home requires heat, the unit will automatically resume the high setting when the
thermostat calls for heat.