Filter
Top Products
Left side heat exchanger
shown
28
9 Using the clean-out tool, tap the side heat exchangers
that are located on the left and right sides of the firebox.
When you open the door, they are located directly inside
to the left and right. When you tap the sides with the
clean-out tool the loose fly-ash will drop out of these
slots.
9 (3500P & 3500L model) Pull the lower front ash
cleanouts out and scrape any fly-ash down into the
pedestal ash pan. Push them back in all the way.
MAINTENANCE INSTRUCTIONS CONTINUED…
Shown with cleanout door pulled
out to open back cleanout hole and
front cleanout.
9 While you are tapping the side heat exchangers, we recommend that you pull the draft knob all the
way out for a minute or two and put the unit on high fire. This will allow the unit to self-clean the
heat exchanger area, the draft fan and exhaust chimney pipe.
9 If a clinker ball develops in the firepot, scrape it out with the clean-out. You may have to do this once
or twice a day depending on the moisture content of the corn. If this is not cleaned out, it could cause
the fuel stirrer to jam. Clinker balls are a direct result of excessive corn moisture and they do not
indicate a problem with the stove. AES highly recommends an additive called “Clean Burn” be added
to your corn to eliminate these clinkers. Contact your local MagnuM Countryside dealer for
availability and cost.
9 Open the stove doors and wipe the inside of the glass with a damp cloth as needed.
SPECIAL CLEANING/OPERATIONAL INSTRUCTIONS WITH UNIT SHUT DOWN:
3500P & 3500L Models: After cleaning or when operating the 3500P & 3500L models you need to make
sure that the clean-out plates are in the closed position. Push the front (2) clean-out slides all the way in
and make sure that you have replaced the left & right clean-out plates that are located on the inside of the
unit. (These plates are located inside the firebox to the left and right of the firepot in the lower corners of
the firebox.) If these plates are not in the closed position the unit will burn dirty.
3502 Insert Models: After cleaning or when operating the model 3502 models you need to make sure that
the clean-out plates are in the closed position. There are clean-out plates that need to be closed. These
are located to the left and right of the firepot inside the firebox in the back lower section of the firebox.
Remove the ash pan, clean out all the ash using ash vacuum and replace the ash pan. Make sure to lock
the ash pan in place.