Filter
Top Products
Page 15
September 1, 2008
R
7007-161H
ZERO CLEARANCE ADJUSTABLE
Included in Kit: 1 trim top; 1 trim front; 2 trim sides;
double-sided tape (already installed)
Tools Required: Phillips head screw driver; sheet metal
shears; measuring tape; gloves
1. The 10 screws on each set of scissors will already be
loose when shipped.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screw driver.
. Measure trim to required height to cover scissors and
mark piece for cutting. Cut excess material from top of
trim’s edge, not bottom. This edge will be sharp; wear
gloves to prevent injury to your hands.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge ts under lip of top, so it allows for
some variance in your straight edge.
5. The double-sided tape that holds the scissors has a par-
ticularly powerful bonding adhesive. Adjustments are
extremely difcult once trim has adhered to tape. Do a
dry run rst without removing paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Install the 2 side pieces rst. The front piece
corners will overlap the side pieces. NOTE: The trim in
the Flush Mount Kit is one piece.
7. Once you are satised with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece.
9. There are holes in the back ange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material in your installation.
NOTE:
/8 inch (9.5mm) thick tile or like material can be cut
to size and t under lip of top trim edge for a decorative touch.
Decorative tile may
be installed
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGH T
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
• Gloves recommended
CAUTION