Filter
Top Products
Page 1
September 1, 2008
R
7007-161H
PANEL and TRIM SET
Panel & Trim Assembly Instructions
or slide trim over the panels after panels are installed.
may have a mantel already in place or where space
is restricted.
1. Lay the panel set face down on protective covering to
prevent scratching the painted surface.
2.
Secure panel set together with screws provided.
. Assemble the trim pieces using the “L” brackets.
.
4. Slide the trim over the panel assembly. (See Note
above).
Included in Kit: (2) side panels, left and right; (1) panel
top; (2) side trim, left and right, (1) top trim (2) “L” brackets,
fastener package and (2) outside air cover boxes
Tools Required: Phillips head screw driver
View of "L" Bracket
installed
1. Remove the insert top (if installed) by lifting up slightly
then pulling towards you and set aside.
2.
T
here are 2 locator pins on the top of the insert to match
up with alignment holes on the back ange of the panel
set.
. On the bottom of ea
ch side of the insert face is a peg.
The bottom of the panel leg will hook onto this peg.
4. Using both hands, hold the panel & trim assembly and
slide it onto the locator pins and then hook the bottom of
the panel legs to the pegs.
5. Place the insert top back into position.
Screw side
panels to top
panel
"L" Bracket
Locator Pin
Slide panel over
locator pin
Hook bottom of
The Outside Air Cover Boxes must be installed