Filter
Top Products
Page 15For technical questions, please call 1-800-444-3353.SKU 3914
Figure 25
3 (detail)
Thread Tension Discs (27a)
Thread Take-up
Eyelet (1b)
Thread Take-up Cover (17a)
Faceplate
Thread
Guide (34a)
Thread Tension
Discs (7a)
3-Hole Thread
Eyelet (31a)
Thread Release
Finger ( 31d)
Thread Guide
(35a)
Take-up Spring
(9a)
5 (detail)
Needle Bar
Thread Guide
(24c)
Presser
Foot (9d)
wire guide
Needle (23c)
Wire Needle
Bar Thread
Guide (26c)
1
2
4
3
5
Pass the thread between the two Thread 1.
Tension Discs (27a) on the top of the
machine.
Pass the thread up through the right 2.
eyelet then down through the left eyelet
on the 3-Hole Thread Eyelet (31a).
Pass the thread between the two Thread 3.
Tension Discs (7a) pulling to the right
until the thread catches in the Take-up
Spring (9a). Then pass under the Thread
Release Finger (31d) and behind the
Thread Guide (35a).
Pass behind the Thread Take-up Cover 4.
(17a), through the Thread Take-up Eyelet
(1b) from right to left, and down through
the Faceplate Thread Guide (34a).
Pass the thread into the Wire Needle Bar 5.
Thread Guide (26c), through the hole
in the Needle Bar Thread Guide (24c),
through the Needle (23c) from left to
right, under the wire guide and between
the opening in the Presser Foot (9d).
To pull the bobbin thread up to the top 6.
of the machine, hold the top thread
behind the Presser foot and turn the
Hand Wheel (7b) counterclockwsie until
the Needle catches the bobbin thread,
REV 10b
Threading the Top Thread
Set the spool of thread (sold separately) onto the top thread Spool
Pin (40i), (the left Spool Pin), and thread it through the eyelet directly
above on the Thread Hanger (28i). Guide the thread through the machine,
following the steps and photos below.
Note: There are two Spool Pins (40i). The left Pin is commonly used to
hold the spool of thread for the top thread (the thread that passes
through the top section of the machine), while the right Pin is used to
hold the spool of thread that is used for winding the bobbin.
Figure 24
Thread Hanger
(28i)
Spool
Pins
(40i)