Filter
Top Products
Hampton
®
H25-1 Direct Vent Freestanding Gas Stove
9
INSTALLATION
9) Place the blower close to the base of the unit and feed the long red
and black wires through the opening of the base of the unit and
connect them to the thermodisc.
10) Feed the short red and black wires through the small hole at the base
of the unit.
11) Mount the blower assembly in position under the base of the stove
and secure with the 2 supplied bolts (2-1/4" #20 hex head)
12) Before re-attaching the rear access panel, the valve wires and the
fan wires need to be connected.
Re-connect the red and grey valve wires.
13) Slide the Rear Access Panel back into position and secure with 2
screws.
Connect the fan wires.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be
plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.