Filter
Top Products
40
Hampton
®
H25-1 Direct Vent Freestanding Gas Stove
11) Carefully lift the burner tray assembly out.
REMOVING VALVE
If your valve requires maintenance or replace-
ment, use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1) If optional fan is installed, disconnect power
source to stove.
2) Remove access panel.
MAINTENANCE
3) Disconnect gas line to stove.
4) Disconnect 3/8" NPT pipe from 90
o
elbow
on valve or fl ex connector.
5) Disconnect the two (2) switch wires from
valve.
6) Disconnect piezo wire.
7) Lift off the Cast Top and lift out the front
door.
8) Carefully remove the logs and embers.
9) Remove burner by removing the 2 screws
on each side and then lifting the burner tray
out.
12) To remove the valve, remove the 4 screws
(2 per bracket) that hold the valve to the
valve bracket assembly.
13) To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly,
continue.
14) Remove two (2) thermopile wires.
15) Remove thermocouple with a 9 mm (metric)
wrench.
16) Remove pilot nut with an 11 mm wrench.
17) Remove valve to orifi ce nut with a 13/16"
wrench.
18) Remove inlet pipe with pipe wrench. Note
orientation of 90
o
elbow.
19) Remove two (2) phillips head M5 screws on
each side of the valve.
20) Remove valve and remove gas out 90
o
brass
fi tting. Note orientation of fi tting.
INSTALLING
VALVE ASSEMBLY
1) To install a new valve assembly, reverse
instructions for removing valve. See as-
sembly steps 1-12.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for
removing valve assembly, steps 13-19.
10) Remove all 6 screws holding the burner
tray assembly in place.
3) Unclip the black and white wires from the
fan motor.
4) Remove the 2 bolts holding the fan to the
rear base. Disconnect the green ground
wire from the right side of the fan as soon
as you can reach it.
Replacing the Fan:
Reverse the above steps (1 - 4). Make sure
the fan wires and the ground wire are reat-
Screws
Note: Use a magnetic type screwdriver if
possible.