Filter
Top Products
7
IMPORTANT SAFETY INSTRUCTIONS
These warning labels should be found at the locations specified below. If any of them are missing, immediately
contact your installer for replacements.
WARNING
!
• Fingers, hands, and
loose clothing may be
dragged into chain
sprockets.
• Fingers and hands can
be injured by rotating
sprockets.
• Keep hands, fingers,
and loose clothing
away from chain and
chain opening in
operator housing.
• Fingers, hands, and loose clothing
may be dragged into chain sprockets.
• Fingers and hands can be injured by
rotating sprockets.
•
Keep hands, fingers, and loose clothing
away from chain and sprockets.
WARNING
!
warning labels (3). Located on both sides and back
of operator housing
warning label located on top
of control box
• Moving parts inside are capable of
causing injury to fingers and hands.
• DO NOT remove operator housing.
• Consult your safety manual before
making adjustments.
•
For service, call an experienced technician.
AUTOMATIC GATE OPENERS 1-800-543-GATE
WARNING
!
warning label located on front of operator housing
product identification and manual operation instruction
label installed on control box cover
RB2002
Maximum Gate: 1000 lb. (453.4 kg); 30 ft. (9.1 m)
Voltage: 12 Vdc; Frequency: 0 Hz; Power: 93.2 W
Class I, II and III Vehicular Slide Gate Operator
Serial Number: SL2000-xxxxxxx
9901178
Conforms to UL 325 STANDARDS
Certified to CAN/CSA-C22.2 No.247-92
Disconnect operator ONLY when the gate is NOT moving.
TO MANUALLY OPEN AND CLOSE THE GATE:
1. Lift quick release pins UP, then pull them OUT of chain brackets.
2. Lay chain down and manually slide gate to desired position.
Series
GTO, Inc. Tallahassee, Florida USA
L
I
S
T
E
D
USC
RB2001
Maximum Gate: 500 lb. (226.7 kg); 30 ft. (9.1 m)
Voltage: 12 Vdc; Frequency: 0 Hz; Power: 93.2 W
Class I, II and III Vehicular Slide Gate Operator
Serial Number: SL1000-xxxxxxx
9901178
Disconnect operator ONLY when the gate is NOT moving.
TO MANUALLY OPEN AND CLOSE THE GATE:
1. Lift quick release pins UP, then pull them OUT of chain brackets.
2. Lay chain down and manually slide gate to desired position.
Series
GTO, Inc. Tallahassee, Florida USA
SL
L
I
S
T
E
D
USC
Conforms to UL 325 STANDARDS
Certified to CAN/CSA-C22.2 No.247-92