GE JGB910 Gas Heater User Manual


 
Customer Service
Operating InstructionsSafety Instructions
Installation Instructions Troubleshooting Tips
39
Oven Shelves
Clean the shelves with an abrasive cleanser
or steel wool. After cleaning, rinse the
shelves with clean water and dry with a
clean cloth.
NOTE: Take the shelves out of the oven before you
begin the self-clean cycle.
Fluorescent Top Light
CAUTION: Do not touch the bulb with wet hands or
when the bulb is hot. Never wipe the light area with
a wet cloth. Electrical power must be shut off if you
have to replace the bulb.
Raise the clips on the back, on both
sides, and free the back of the canopy.
Roll the canopy up and off.
Remove the fluorescent light bulb.
Replace the bulb with one of the same
length and wattage.
Replace the canopy by placing the
front in the groove and rolling it back.
Snap it into place over the back clips on
both sides.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel. Be sure to let the
light cover and bulb cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn’t fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove the
cover.
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds
the cover firmly. Be certain the wire is
in the depression in the center of the
cover.
Connect electrical power to the range.
Wire cover holder.