Filter
Top Products
Fork arm
Attaching head
Presser bar attaching screw
Needle
Needle
screw & clamp
Needle bar
Presser foot bar
Fork arm
* The walking foot accessory is optional. It is not included with this
machine.
Always try to sew first without the walking foot accessory
which should be used only when necessary.
It is easier to guide the fabric and you have a better view of the
seam when using the standard, regular foot on your machine. Your
EURO-PRO sewing machine offers excellent stitch quality on a
wide range of fabrics from delicate chiffons to multiple layers of
denim.
The "Walking foot" accessory equalizes the feeding of the upper
and lower layers of fabric and improves the matching of plaids,
stripes and patterns. This foot helps to prevent uneven feeding of
very difficult fabrics.
1. Lift the presser foot bar.
2. Remove the "foot holder" by opening counter clockwise the
presser bar attaching screw. (3)
3. Attach the "walking foot" to the machine in the following way.
I) The fork arm should fit into the needle screw and clamp. (2)
ii) Slide the plastic 'attaching head' from your left to right so
that it is fitted into the "presser foot bar"
iii) Lower the 'presser foot bar'.
iv) Replace and tighten clockwise the "presser bar attaching
screw"
4. Make sure both the 'needle screw' and the 'presser bar
attaching screw' are tightly secured.
5. Draw the bobbin thread up and place both the bobbin thread
and the needle thread behind the walking foot attachment.
1 2
3
42