Filter
Top Products
1
2
Set the machine as illustrated above.
Remove the presser foot and the presser foot holder.
Attach the darning plate.
Lower presser foot lever before starting to sew.
Adjust the stitch width according to the size of lettering or design.
Preparation for Monogramming and Embroidering
Draw the desired lettering or design on the right side of the fabric.
Stretch the fabric between embroidery hoop as firmly as possible.
Place the fabric under the needle. Make sure the presser foot bar is down in its lowest
position.
Turn the balance wheel towards you to bring up the lower thread through the fabric.
Sew a few securing stitches at the starting point.
Hold the hoop with thumb and forefingers of both hands while pressing the material with
the middle and third fingers and supporting the outside of hoop withe smaller finger.
*Embroidery hoop not included with machine.
44