Filter
Top Products
1
2
3
4
5
6
Cutter
Attention:
Turn power switch to off ("O"). Raise the needle bar.
Follow completely the numbered sequence in upper threading. Should you
skip or fail to properly engage the thread with any of the thread guides, you will
not sew properly. (1-5)
Continue to draw the thread down and into the needle bar thread guide. Pass
the thread through the eye of the needle from front to back. Leave loose about
10 cm (4") of thread. (6)
Atencio n:
El interruptor principal tiene que estar a ("O"). Subir la prensatela.
Enhebre la aguja por las siguientes posiciones: Guiahilos de tapa superior,
regulador de tensio n, muelle de tirahilos, palanca tirahilos, guiahilo del brazo,
guiahilo de la barra de aguja. (1-5)
Enhebre la aguja pasando el hilo desde el frente hacia el reverso por el ojo de
la aguja y deje ma s o menos 10 cm (4 pulgadas) hilo. (6)
13