Filter
Top Products
EMULEX MODEL 355 SAN STORAGE SWITCH
USER’S GUIDE APPENDIX B: CLI QUICK REFERENCE
EMULEX CORPORATION 61
P
ART NUMBER 00041407-002 REV. B
USING THE CLI
The CLI enables users to monitor and change system and port configurations, configure One-Step
Zoning, Automatic Trunking, Load Balancing, and event reporting parameters, and download and install
firmware.
For additional information on the CLI, see the
Emulex® or InSpeed™ Storage Switch Products’ CLI
Reference Guide
.
To enter a command:
Type the command text or the number of the command.
To return to the previous menu:
Type .. and press E
NTER.
To return directly to the Root menu:
Type root and press E
NTER.
To cancel a prompt or input request:
Press E
NTER.
To display help for specific command:
Type ? <command> and press E
NTER.
To save changes to the switch configuration at any time:
1. Type save at any command prompt and press E
NTER.
A message appears confirming the request.
2. Type y and press E
NTER.
FREQUENT SWITCH CONFIGURATION TASKS
A list of frequent switch configuration-related tasks is provided below. The list displays the task and the
corresponding CLI command.
To… Type…
View switch status show sysinfo
Change general switch configuration config sys
Change the IP Address config network ip
Change the switch speed config sys speed
View the event log show events
Upgrade the firmware fw
Change the port settings config port
Configure zoning config zone
Configure trunking config load
Configure load balancing config trunk
Reset the switch reset
Perform diagnostics diag
Reset the switch to factory default settings config default
Change the password config password