Filter
Top Products
www.elationlighting.com!
S)!!!!!!!!!!!!!!!!!!!!!!!!!"#$%&"'()*'+,-.'/01203'!45
EDIT PROGRAM – Record Controller – Working With Built-In Program
[continued]
To start an Auto Program proceed as follows:
1. Slave Setting
• Select “Function Mode” by turning on the encoder.
• Press the ENTER button to confirm.
• Select “Set to Slave” by turning the encoder.
• Press the ENTER button to confirm.
• Turn the encoder to select “Slave 1”, “Slave 2” or “Slave 3”.
• Press the ENTER button to confirm.
• Press the MODE/ESC button in order to return to the main menu.
2. Automatic Program Run
• Select “Function Mode” by turning on the encoder.
• Press the ENTER button to confirm.
• Select “Auto Program” by turning on the encoder.
• Press the ENTER button to confirm.
• Turn the encoder to select “Master” or “Alone”. The selection "Alone" means
Stand Alone-mode and "Master" that the device is defined as master.
• Press the ENTER button to confirm.
• Press the MODE/ESC button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select “Edit Program” by turning the encoder.
• Press the ENTER button to confirm.
• Select “Select Programs” by turning the encoder.
• Press the ENTER button to confirm.
• Turn the encoder to select “Auto Pro Part 1”, “Auto Pro Part 2” or “Auto Pro
Part 3”, and thus select which Slave program is to be sent. Selection “Part 1”
means, that the Slave unit runs the same program as the master units.
• Press the ENTER button to confirm.
• Press the MODE/ESC button in order to return to the main menu.