Filter
Top Products
www.elationlighting.com!
SV!!!!!!!!!!!!!!!!!!!!!!!!!"#$%&"'()*'+,-.'/01203'!45
EDIT PROGRAM – Edit Scenes
Edit the scenes of the internal programs.
1. Tap MODE/ESC to access the main menu, tap UP/DOWN/LEFT/RIGHT until
“Edit Program” is highlighted and tap ENTER.
2. Tap UP/DOWN until “Edit Scenes” is displayed and tap ENTER.
3. Tap UP/DOWN to select desired Scene number (“Scene 001” - “Scene 250”)
and tap ENTER to confirm selection.
4. Tap UP/DOWN to select desired function (“Auto Program”, “PAN”,
“PAN-Fine”, “TILT”, “TILT-Fine”, “Move Speed”, “Strobe”, “Dimmer”,
“Red(1-4)”, “Green(1-4)”, “Blue(1-4)”, “White(1-4)”, “Color Macro”, “Color
Preset”, “Color Mode”, “Color Patter”, “Chase Speed”, “Fade Time”,
“Secne Time”, “Input By Out”) and tap ENTER to confirm selection.
5. Tap UP/DOWN to select desired position (“0-255”) and tap ENTER to confirm
selection.
6. Tap MODE/ESC to return to the main menu.
EDIT PROGRAM – Record Controller
The fixture features an integrated DMX-recorder by which you can transmit the
programmed scenes from your DMX-controller to the moving head. Adjust the
desired scene numbers via the encoder (from – to). When you call up the scenes at
your controller, they will automatically be transmitted to the moving head.
EDIT PROGRAM – Record Controller – Working With Built In Program
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master
unit can start 3 different Slave units, which run 3 different programs. The Master unit
sends the 3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the
Slave unit was assigned to. If e.g. a Slave unit is set to “Slave 1” in the menu “Set
to Slave”, the Master unit sends “Auto Program Part 1” to the Slave unit.
If set to “Slave 2”, the Slave unit receives “Auto Program Part 2”.