Filter
Top Products
www.elationlighting.com!
!X!!!!!!!!!!!!!!!!!!!!!!!!!"#$%&"'()*'+,-.'/01203'!45
PERSONALITY - Service Setting - RDM PID
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "remote device management" and
makes remote control of devices connected to the DMX-bus. ANSI E1.20-2006 by
ESTA specifies the RDM standard as an extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This
is especially useful when the fixture is installed in a remote area. RDM ready and
conventional DMX devices can be operated in one DMX line. The RDM protocol
sends own packages in the DMX512 data feed and does not influence conventional
devices.
If DMX splitters are used and RDM control is to be used, these splitters must
support RDM. The number and type of RDM parameters depend on the RDM
controller being used.
1. Tap MODE/ESC to access the main menu, tap UP/DOWN/LEFT/RIGHT until
“Personality” is highlighted and tap ENTER.
2. Tap UP/DOWN until “Service Setting” is displayed and tap ENTER.
3. Tap UP/DOWN until “RDM PID” is displayed and tap ENTER.
4. Tap MODE/ESC to return to the main menu.
PERSONALITY – Fans Control
Select desired Fan setting, default is Auto.
1. Tap MODE/ESC to access the main menu, tap UP/DOWN/LEFT/RIGHT until
“Personality” is highlighted and tap ENTER.
2. Tap UP/DOWN until “Fans Control” is displayed and tap ENTER.
3. Tap UP/DOWN to select desired mode (“Auto”, “Low”, “High”) and tap
ENTER to confirm selection.
4. Tap MODE/ESC to return to the main menu.