Filter
Top Products
SCS-1R Installation Guide Digital Monitoring Products
21
opeRatoR’s GuIde
CHANGE REC KEY
SURE? YES NO
Change Receiver Key
After entering the desired Receiver Key and pressing COMMAND, the SURE? YES NO
prompt displays. Press the Select key under YES to keep the new key, or under NO to
use the previously stored key.
RECEIVER KEY
CHANGED
Receiver Key Changed
After pressing the Select key under YES, the display indicates that the receiver key has
been successfully changed.
RECEIVER HOURS
FROM GMT: 6
Receiver Hours From GMT
Number of hours (0 to 23), from the Greenwich Time zone (GMT), where the receiver is
located. Refer to the table below for various cities and GMT settings. Default is 6.
GMT City/Time Zone GMT City/Time Zone
0 London, Monrovia, Lisbon, Dublin, Casablanca, Edinburgh 13 New Cadelonia
1 Cape Verde Island, Azores 14 Guam, Sydney
2 Mid-Atlantic, Fernando de Noronha 15 Tokyo, Seoul
3 Buenos Aires, Georgetown, Brasilia, Rio de Janeiro 16 Hong Kong, Singapore
4 Atlantic Time (Canada), Caracas, La Paz, Santiago 17 Bangkok, Hanoi
5 Eastern Time (US, Canada) Bogota, Lima, Arequipa 18 Dhaka, Almaty
6 Central Time (US, Canada), Mexico City, Saskatchewan 19 Islamabad, Karachi
7 Mountain Time (US, Canada), Edmonton 20 Abu Dhabi, Kazan
8 Pacic Time (US, Canada), Tijuana 21 Moscow, Bagdad
9 Alaska 22 Eastern Europe
10 Hawaii 23 Rome, Paris, Berlin
11 Midway Island, Samoa
12 Fiji, Marshall Island, Wellington, Auckland, Kwajalein, Kamchatka
DIALER LINE CARD
MONITOR? NO YES
Dialer Line Card Monitor
Press the far right Select key for YES to enable monitoring of all SCS-100 digital dialer
line cards for any failed communication attempts. A failed communication attempt
occurs when the line card goes off hook but does not successfully communicate with
a panel. Press the middle right Select key for NO, to disable the line card monitoring
operation. Default is NO.
When enabled, and a line card communication fails, a message, S61 through S65 (Line
1-5 respectively), is sent to the host automation computer, SCS-1R printer and LCD
display. Manual acknowledgement is required when the SCS-1R is not successfully
communicating with the host automation computer.
Line Cards
This section assigns the line number and line type for all line cards connected to the SCS-150.
SCS-1R MENU
LINE CARDS
Line Cards
Press any top row Select key to assign the line number and line type for each line card
connected to the SCS-150.
LINE NUMBER: X
Line Number
Press any top row Select key to clear the display and enter a new line number. Enter
the line number, 1 through 5, for which the communication method is to be specied.
LINE NUMBER: X
TYPE: XXXX
Line Type
The display shows the current setting for the line type. Press any top row Select key to
change the Line Type. Press the Select key under the communication method for this
line. NET for Data Network communication for use with data networks. DD for DMP
Digital Dialer. NONE to clear all information for the line. Line 1 defaults to NET and
lines 2 through 5 default to DD. After you select the line type, the display returns to
LINE NUMBER: to program the other lines.
SEND TIME CHANGE
TO PNLS? NO YES
Send Time Change
Press the top row Select key under YES to allow the SCS-1R to send time changes to
panels that communicate to the receiver on this line card. Select NO to prevent the
SCS-1R Receiver from sending time changes.
LINE TYPE
NONE DD NET