Filter
Top Products
25
3.3.2 LAN
In this window you may change the parameters of the LAN interface to be found on both Vega Wireless
Camera versions.
Enter the value you wish to change and click SAVE. The new settings will be immediately effective.
IP Address: insert the IP address the camera will use for transmission on the LAN port.
WARNING: the IP address of the LAN interface must belong to another network than the IP
address of the WLAN interface.
After changing the IP address of the Vega Wireless Camera, switch off the device and switch on after
10 seconds. You may be asked to modify also the IP address of the computer, in order to proceed with
the camera configuration.
Mask: insert the Subnet mask value.
Default Gateway: insert the IP address of the Gateway.
Mac Address: this window shows the Mac Address value of the camera.