Filter
Top Products
18
2.4.2 POWER SUPPLY OUTPUTS
The Vega Wireless Camera’s clamp strip is provided with 2 power supply outputs to power any possible
presence detection sensor.
To power the sensor you only need to connect the Vega Wireless Camera’s pin 1 to the positive contact (+)
of the presence detector and the Vega Wireless Camera’s pin 3 to the negative contact (–) of the presence
detector. To connect and power a second presence detector you must connect the Vega Wireless Camera’s
pin 4 to the positive contact (+) of the presence detector and the Vega Wireless Camera’s pin 6 to the
negative contact (–) of the presence detector.
When using the backup battery, the power supply outputs are subject to a deterioration of around 3
Volts.
2.4.3 CONNECTION OF A PRESENCE DETECTOR TO THE VEGA WIRELESS CAMERA
Together with the above-mentioned information, herewith you will find a diagram and a table with the
description of the pins to use for a direct connection of a presence detector to the Vega Wireless Camera.
PRESENCE DETECTOR VEGA WIRELESS CAMERA
PIN + PIN 1
PIN – PIN 3
PIN N PIN 2
PIN C PIN 3
PRESENCE D
ETECTOR
VEGA WIRELESS CAMERA