Filter
Top Products
16
2.3a LED DESCRIPTION (VEGA WIRELESS CAMERA WLAN)
Three LED options indicate a different camera status, as follows:
• PWR: Vega Wireless Camera’s power
• SIGNAL: information on WLAN connection
• STATUS: information on remote connection
The LEDs can act as follows:
PWR SIGNAL STATUS
OFF Camera is OFF OFF WLAN unit is OFF OFF
Image capture is
OFF
Blinking - Blinking - Blinking -
ON Camera is ON ON WLAN unit is ON ON
Image capture is
ON
When the Vega Wireless Camera WLAN is powered, the device goes through the following stages:
1. Vega Wireless Camera’s power: PWR LED is ON;
2. Start of the Operating System: LED is steady ON for about 30 seconds;
3. Status LED steady ON for about 10 seconds;
4. WLAN unit identification: Status LED turns OFF and SIGNAL LED turns ON in the rear panel. In case of
problems with the WLAN unit, the Status LED will blink for about 10 seconds and the Vega Wireless Camera
can be used only through the LAN port.
5. Start of the image capture after about 2 minutes: Status LED is ON.
2.3b LED DESCRIPTION (VEGA WIRELESS CAMERA GPRS)
Three LED options indicate a different camera status, as follows:
• PWR: Vega Wireless Camera’s power
• SIGNAL: information on GSM network
• STATUS: information on remote connection
PWR L
ED
SIGNAL L
ED
RESET
button
LAN
port
SIM Card slot
(for Vega Wireless Camera GPRS)
INPUT
clamp
strip
Antenna connector
PWR
connector