Filter
Top Products
www.desatech.com
113110-01A
21
Figure 33 - Back View of Thermostat
Base
Feed wires through rectangular slots
W
R
Figure 34 - Thermostat Base Terminals
“W” and “R”
Terminal “W”
Terminal “R”
INSTALLATION
Continued
6. Connect one bare wire end to each terminal (“W”
and “R”) of the thermostat base (see Figure 34).
7. Install the base onto the wall with the pro-
vided screws.
8. Move the temperature adjustment back and forth
to insure the bimetal is free from restrictions.
9. Replace the cover onto the base. (Upon in-
stallation, the thermostat must be allowed to
stabilize at room temperature for a minimum
of 30 minutes for proper operation).
10. Set switch on fireplace to Auto position.
11. Set the temperature adjustment to the desired
setting. This thermostat has been electroni-
cally calibrated at the factory. No adjustment
or leveling is necessary.
Log
Shoulder
Screw
Screen
OPTIONAL WALL SWITCH - GWMS2
WARNING: Read and follow
installation instructions. Instal-
lation should be done by a quali-
fied installer familiar with low-
voltage wiring procedures.
WARNING: Do not connect
this switch to any electrical
source! Electrical shock and/or
fire hazard will occur.
1. Connect one terminal of 25 ft. wire to bottom
contact of switch (see Figure 32, page 20).
2. Connect remaining wire terminal to the “TH”
terminal on the control valve. Make sure that
wire terminals are in the positions on your unit
as pictured in Figure 32, page 20. If wires are
not “crossed” the thermostat will not work.
3. Route the 25 ft. wire to a convenient location
to mount your wall switch (no outside walls).
WARNING: Do not connect
the switch to a power source.
Electrical shock and/or fire haz-
ard will occur.
IMPORTANT:
The wire may be shortened but
must not be lengthened.
4. Connect one bare wire end to each of the ter-
minals of the provided wall switch.
5. Install the wall switch and cover in the wall.
INSTALLING LOG SET AND
SCREEN
1. Remove log packaging material and discard
packaging. Gently place log on burner sup-
port (see Figure 35). The log should fit flat
against top of burner support and log locator
tabs fit into the slots under the log. Do not
allow log to contact flame. If flame contacts
log, soot will be created.
2. Reattach screen by placing the notches in the
screen frame over the shoulder screws and
pushing down.
Burner Support
with Log
Locator Tabs
Figure 35 - Installing Log and Screen