Filter
Top Products
106918-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
23
23
9. Push in the control knob all the way and hold in. Immedi-
ately light the pilot by pressing the ignitor button until a
flame appears one (1) minute after the pilot is lit. Release
knob and it will pop back up. Pilot should remain lit. If it
goes out, repeat steps 5 through 9, starting on page 23.
• If knob does not pop out when released, stop and call gas
supplier.
• If the pilot will not stay lit after several tries, turn gas
control knob to “OFF” and call your service technician
or gas supplier.
10. Turn gas control knob counterclockwise to “ON”.
Knob can be turned to “ON” only if the control knob is
popped out.
11. Set “HI-LO” knob to desired setting.
12. Turn on all electric power to the appliance.
Figure 50 - Control Knob in the PILOT Position
O
F
F
P
I
L
O
T
O
N
L
O
H
I
P
I
L
O
T
EA
16AI
7
TPTH TP TH
Position
Indicator
Gas Control Knob
HI/LO Knob
TO TURN OFF GAS
TO APPLIANCE
1. Turn off the wall switch.
2. Turn off all electric power to the appliance if service is to
be performed.
3. Remove control access panel.
4. Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
5. Replace control access panel.
OPERATING FIREPLACE
Lighting Instructions (Cont.)
To Turn Off Gas to Appliance
Optional Remote Operation
Figure 51 - Pilot
OPTIONAL REMOTE
OPERATION
NOTICE: You must light the pilot before using the
hand-held remote control unit. See
Lighting Instruc-
tions
, page 22.
Note:
All remote control accessories must be purchased sepa-
rately (see Accessories, page 28). Follow instructions included
with the remote control.
OPERATING FIREPLACE
Continued
Thermocouple
Pilot Burner
Piezo Ignitor
Thermopile
ON
OFF
REMOTE
O
F
F
P
I
L
O
T
O
N
L
O
I
H
Figure 52 - Setting the Selector Switch, Control Knob, and
Flame Adjustment Knob for Remote Operation
Flame Adjustment Knob
Selector Switch in Remote Position
(Optional Remote Control)
Control Knob
in ON Position
1. After lighting, let pilot flame burn for about one minute.
Turn control knob to ON position. Adjust flame adjustment
knob anywhere between HI and LO. Slide the selector switch
to the REMOTE position.
Note:
The burners may light if
hand-held remote ON button was on when selector switch
was last turned off. You can now turn the burners on and off
with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch in the RE-
MOTE position when the pilot is not lit. This will drain the
battery.
IMPORTANT:
Be sure to press the ON/OFF buttons on the
hand-held remote control unit for up to 3 seconds to assure
proper operation.
2. Press ON/OFF button to turn the burners on and off. When
turning burners off, the pilot will remain lit.