Filter
Top Products
108954
3
3
Side Cover
Lower
Shell
Fuel
Cap
Hot Air Outlet
Upper Shell
Power Cord
Fuel
Tank
Fan
Guard
Lower
Shell
Side Cover
Fuel
Tank
Upper
Shell
Hot Air
Outlet
Handle
Fan Guard
Air Filter
End
Cover
Fuel Cap
Power
Cord
ON/OFF Switch
with Light
ON/OFF
Switch with
Light
PRODUCT IDENTIFICATION
Figure 1 - Model GK20
Figure 2 - Model GK30
UNPACKING
1. Remove all packing items applied to heater for shipment.
2. Remove all items from carton.
3. Check items for any shipping damage. If heater is damaged,
promptly inform dealer where you bought heater.
PRODUCT IDENTIFICATION
UNPACKING
ASSEMBLY
Screw
Wheel
Support
Frame
Wheel
Cap Nut
Nut
Extended
Hub
Front Handle
Axle
Rear
Handle
Air
Inlet
Fuel Tank
Flange
Hot Air
Outlet
ASSEMBLY
(FOR MODEL GK30 ONLY)
These models are furnished with wheels and handles. Wheels, handles,
and the mounting hardware are found in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame. Install wheels on axle.
IMPORTANT:
When installing wheels, point extended hub of
wheels toward wheel support frame (see Figure 3).
2. Place cap nuts on axle ends. Gently tap with hammer to secure.
3. Place heater on wheel support frame. Make sure air inlet end
(rear) of heater is over wheels. Line up holes on fuel tank flange
with holes on wheel support frame.
4. Place front handle and rear handle on top of fuel tank flange.
Insert screws through handles, fuel tank flange, and wheel sup-
port frame. Attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
Figure 3 - Wheel and Handle Assembly for Model GKL30