Filter
Top Products
105501-01F
For more information, visit www.desatech.com
For more information, visit www.desatech.com
22
Figure 49 - Removing Front Panel from Stove
Bolt
Bolt
Stove Front Panel
Figure 50 - Removing Glass Door from Burner System Insert
Screw
Glass
Door
STOVE AND DIRECT-VENT
BURNER SYSTEM INSTALLATION
Continued
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with freestanding burner system. Do not use if any log(s)
are broken (see Replacement Parts, page 36).
1. Remove glass door. See Removing/Replacing Glass Door, page 21.
2. Place log #1 (back log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 51).
3. Rest log #2 (large front log) on the pins on the front part of the
grate (see Figure 52).
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this burner system may
result in property damage or personal injury.
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
NOTICE: Do not put lava rock on burner or under
burner. Placing lava rock on burner could cause
performance problems.
4. Place log #3 (left piece) onto the front left part of the grate.
Make sure it is seated properly over the prong of the grate as
shown in Figure 53.
5. Place log #4 (right piece) onto the front right part of the grate
making sure the notches fit over the prong of the grate (see
Figure 54).
6. Place lava rock along sides and front of inside of burner system
bottom. It is not necessary to use all of the lava rock provided.
STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION
Removing/Replacing Glass Door (Cont.)
Installing Logs, Lava Rock and Glowing Embers
1
Figure 51 - Installing Log No. 1
2
3
4
Figure 52 - Installing Log No. 2
Figure 53 - Installing Log No. 3
Figure 54 - Installing Log No. 4