Filter
Top Products
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property
damage, personal injury or loss of life. Refer to the owner’s information manual provided with this
appliance. Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
HEATERS INSTALLED ABOVE 4,500 FT. MAY EXPERIENCE NUISANCE PILOT
OUTAGE AND THIS CONDITION MAY BE AGGRAVATED BY IMPROPER GAS
SUPPLY PRESSURE AND/OR INCORRECT SIZING RELATIVE TO FREE AIR OR
CONFINED SPACE.
INTRODUCTION………………………. 2, 3
SPECIFICATIONS……………………… 3
SAFETY INSTRUCTIONS…………….. 3, 4
FRESH AIR FOR COMBUSTION VENTI-
LATION & AIR DISTRIBUTION……. 4, 5
INSTALLATION……………………….. 5, 6
CLEARANCES…………………………. 6
TOOLS & ADDITIONAL SUPPLIES….. 6
GAS ROUGH-IN………………………… 6
WALL MOUNT…………………………. 9
FREE STANDING………………………. 9
GAS CONNECTION……………………………. 10
LIGHTING INSTRUCTIONS……………………....... 11
PROPER OPERATION…………………………......... 12
MAINTENANCE……………………………….......... 13
BLOWER INSTRUCTIONS……………………......... 14
TROUBLE SHOOTING GUIDE………………........... 15
ILLUSTRATED PARTS BREAKDOWN………....... 16
PARTS LIST…………………………………….......... 17
WARRANTY…………………………………............ 18
L.P. GAS WARNING SHEET…………….........……. 19
INTRODUCTION
Read these installation and operating instructions carefully before you install or attempt to use this vent free
room heater. If you do not understand any part of these instructions, consult local authorities, a qualified
installer, service agency, or the gas supplier. FAILURE TO READ OR UNDERSTAND THESE
INSTRUCTIONS CAN RESULT IN MALFUNCTION, INEFFICIENT OPERATION,
PROPERTY DAMAGE, SERIOUS INJURY OR DEATH.
These installation instructions are a general guide and do not supersede applicable local codes and
ordinances. Before planning or beginning the installation be sure it complies with all phases of the local
heating code. Or, in the absence of local codes, with the latest edition of the National Fuel Gas Code,
ANSI.Z223.1. A copy of which is available from the American Gas Association, 1515 Wilson Blvd.,
Arlington, Virginia 22209.
The design of this appliance was certified to comply with the latest edition of ANSI Z21.11.2, also available
from the American Gas Association.
CONTENT
Page 2