Filter
Top Products
17
USING THE MOTION DETECTING CONTROL PANEL
(optional accessory)
Press the push bar (1) to open or close the door. Press again to stop the door.
Light feature
Press the light button to turn the opener light on or off. It will not control the opener
lights when the door is in motion. If you turn it on and then activate the opener, the
light will remain on for 2 1/2 minutes. Press again to turn it off sooner. The 2 1/2
minute interval can be changed to 1-1/2, 3-1/2 or 4-1/2 minutes as follows: Press
and hold the Lock button until the light flashes (about 10 seconds). A single flash
indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light
will flash twice, resetting the timer to 2-1/2 minutes. Repeat again for 3-1/2 minute
interval, etc, up to a maximum of four flashes and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held transmitters. However, the
door will open and close from the Door Control, the Outside Keyswitch and the
Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds. The push bar light will
flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds. The push bar light
will stop flashing.
The Lock feature will also turn off whenever the “LEARN” button on the opener panel
is activated.
30
LOCK
LIGHT
A
8
7
SPECIAL FEATURES
A. Door within a door connection
Open light lens. Locate auxiliary quick connect terminals 7 and 8. Remove factory installed
link. Insert bell wire into quick connect terminals 7 and 8.
31