Filter
Top Products
15
1
2
1
3
4
LOCK
LIGH
T
2
LOC
K
LIGH
T
3
LOC
K
LIGHT
NOTE: Your new Keyless Entry must be
programmed to operate your garage door opener.
Program the Receiver to Match Additional
Transmitter Code
Using the orange “LEARN” Button:
1. Press and release the orange “learn” button (1) on
opener. The learn indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, enter a four digit personal
identification number (PIN) of your choice on the
keypad (2), then press and hold the ENTER button.
3. Release the button when the opener light flashes (3).
It has learned the code. If the light bulb is not
installed, two clicks will be heard.
NOTE: This method requires two people if the
Keyless Entry is already mounted outside the
garage.
Using the Motion Detecting Control Panel:
4. Enter a four digit personal identification number (PIN)
of your choice on the keypad, then press and hold
ENTER.
5. While holding the ENTER button, press and hold the
LIGHT button on the Motion Detecting Control Panel.
6. Continue holding the ENTER and LIGHT buttons
while you press the push bar on the Motion Detection
Control Panel (all three buttons are held).
7. Release buttons when the opener light flashes. It has
learned the code. If the light bulb is not installed, two
clicks will be heard.
PROGRAMMING C379 WIRELESS
FINGERPRINT ACCESS SYSTEM
(OPTIONAL ACCESSORY)
Full instruction are available with this accessory.
Once you have enroled your user into the C379 you
can program the unit into your opener.
Using the orange “LEARN” Button:
1. Press and release the orange “learn” button (1) on
opener. The learn indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, slide the cover of the C379 up as
illustrated (A). Swipe your finger on the reader head
at a steady speed (B) until the yellow led turnes on
(C).
3. When the opener light flashes (3). It has learned the
code. If the light bulb is not installed, two clicks will
be heard, ensure there are no obstructions in the
path of the door, then press the Send button (D) to
test the door.
28
KEYLESS DEVICES PROGRAMMING (OPTIONAL ACCESSORIES)