Filter
Top Products
14
INSTALLING THE CM128 WIRELESS WALL BUTTON (OPTIONAL)
Carefully pry open the CM128 and locate the two screw for
mounting.
To attach to the wall, use the two screws and wall anchors provided if
mount to plaster wall (if using a recessed wall box do not use anchors).
NOTE: Tightening the wall mount screws will reduce clearance
between bracket and wall.
NOTE: Your CM128 Wireless door controller should be pre-
programmed into your unit, you should only need to program
additional units.
Program the Wall control into the Rolling Code Receiver
Using the orange “LEARN” Button:
1. Press and hold down the button you wish to program to the
opener. The orange LED will flash to indiciate it is receiving signal from
the transmitter.
2. Press and release the “LRN” button.
3. The sourtesy LEDs will flash once.
Ensure the door is clear of obstruction, then test the transmitter.
+
+
+
26
Locate minimum 1.5m above
the floor.
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
NOTE: The transmitter(s) and wall button supplied with
your opener are factory programmed.
If you purchase additional transmitters, the garage door
opener must be programmed to accept the new remote
code.
Program the Receiver to Match Additional Transmitter
Codes:
Using the orange “LEARN” Button:
1. Press and hold down the transmitter button you wish to
program to the opener. The orange LED will flash to
indiciate it is receiving signal from the transmitter.
2. Press and release the “LRN” button.
3. The sourtesy LEDs will flash once.
Ensure the door is clear of obstruction, then test the
transmitter.
Using the Motion Detecting Control Panel
(optional accessory):
1. Press and hold the button on the hand-held remote that
you wish to operate your garage door (1).
2. While holding the remote button, press and hold the
LIGHT button on the Motion Detecting Control Panel (2).
3. Continue holding both buttons while you press the push
bar on the Motion Detecting Control Panel (all three
buttons are held) (3).
4. Release buttons when the opener light flashes. It has
learned the code. If the light bulb is not installed, two
clicks will be heard (4).
Now the opener will operate when the transmitter push
button is pressed. If you release the transmitter push button
before the opener light flashes, the opener has not learned
the code.
To Erase all Transmitter Codes:
To deactivate any unwanted remote, first erase all codes:
Press and hold the orange “learn” button on opener until
the learn indicator light goes out (approximately 6 seconds).
All previous codes are now erased. Reprogram each remote or keyless entry
you wish to use.
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No
one should enter or leave garage while door is in motion. Do not allow children to operate push
button(s) or remote(s). Do not allow children to play near the door.
27
1
3
2
m
m
ee
rr
ll
ii
nn
++
1
3
2
4
LOCK
LIGHT
LOCK
LIGHT
m
m
ee
rr
ll
ii
nn
++