Filter
Top Products
Brookhaven Direct Vent Gas Fireplace
18
10009459
6. Place the log front (J12). Place the two underside
holes of the log over the two pin studs of the bracket
on the left and right sides of the front burner hous-
ing. (Fig. 32)
7. Place ember material on top of burner. Scatter the
ember material over the tiles on the front area of the
burner housing. (Fig. 31) Do not pack the ember
material. Separate it when unpacking and keep it in
a fluffy and loose condition for more realistic ember
effect.
8. Place large lava rock onto the two sides of the
burner tray. (Fig. 31)
Do not place any of the lava rock material
on the burner housing assembly.
Log Front (J12)
Figure 32
LG470
Installation of Logs
The logs are fragile and should be handled
with care. Keep the packaging material out
of the reach of children and dispose of the
mterial in a safe manner.
The individual logs can be easily identified
by the numbers cast on the underside of
each log.
LOGS 20DVT
Log Rear J11
Log Front J12
Log Identification Chart
Log Installation
1. Remove cast front assembly.
2. Remove window frame assembly.
3. Remove log box from inside firebox.
4. Unpack the logs from packaging and remove
each log from its wrapping material. Set aside
the ember and the lava rock bags.
As with all plastic bags - these are not
toys and should be kept away from
children and infants.
5. Place the log rear (J11). Place the two under
-
side holes of the log over the two pin studs of
the bracket on the left and right sides of the
burner housing. (Fig. 31)
Log Rear (J11)
Figure 31
Ember
Material
Lava Rock
LG471