Casio QV-11 Plumbing Product User Manual


 
49
Playing Back Images
Playing Back Images
This section describes how to recall and view images stored in cam-
era memory.
Displaying Images on the Camera’s LCD
The QV-10 can store up to 96 images in memory. Images are se-
quentially numbered from 1 through 96. Think of camera memory like
a 96-page album of the images you record.
The following procedure describes how to display images on the
camera’s built-in LCD.
1. Enter the Playback Mode.
Slide the function switch to the
PLAY position.
2. Turn on the camera.
Slide the POWER switch in the di-
rection indicated by the arrow.
The POWER switch automatically
slides back to its original position
when you release it.
When power comes on, the page
that was displayed when you last
turned power off appears on the
LCD.
You can perform steps 1 and 2 in
either order (1 then 2, or 2 then 1).
Operation
50
3. Scroll through the memory pages until the image you want
to view is displayed.
Press [+] to display the next memory page or [–] to display
the previous memory page.
Notes
If you set the function switch to PLAY after recording an image, that
image appears on the LCD first.
The message “MEMORY EMPTY” appears on the LCD if there are
no images stored in memory when you enter the Playback Mode.
51
Playing Back Images
After connecting the camera and TV, set the
channel of the TV to the channel used for video
input.
Displaying Images on a TV Screen
Use the special video cable that comes with the camera to connect
the QV-10 to a television as illustrated below, and you can then view
the images stored in camera memory on the TV’s screen.
Important!
The camera can be connected only to a TV that is equipped with a
VIDEO IN terminal.
Make sure that the power of both the camera and the TV are turned
off when making connections.
TV
Accessory video cable
VIDEO OUT terminal
VIDEO IN terminal
After connecting the camera and TV, use the same procedures as
those described under “Displaying Images on the Camera’s LCD” on
page 49.
Important!
Note that only images already stored in camera memory can be
viewed on the TV screen. If you change to the camera’s Record
Mode, the image picked up by the camera’s lens will not appear on
the TV screen.
Operation
52
Displaying the Memory Page Number
The memory page number is a value in the upper right corner of the
LCD that indicates the number of the currently shown memory page.
1. Enter the Playback Mode.
Set the function switch to the
PLAY position.
2. Press the DISP button.
The memory page number ap-
pears in the upper right corner of
the LCD.
To clear the memory page num-
ber from the LCD, press the DISP
button again.
Notes
The letter “P” next to the memory page number indicates that page
is “protected” and cannot be deleted. See page 67 for details about
protecting memory pages.
Note that turning display of the memory page number on and off in
the Playback Mode also affects the display of the image number in
the Record Mode (page 43), and the zoom area indicator used in
the zoom operation (page 58).