Filter
Top Products
Enabling and Disabling Link/Seg Traps 3-3
Link/Seg Traps
from the Hub View:
1. Click on to display the Device menu.
2. Drag down to Link/Seg Traps and release.
from the command line (stand-alone mode):
1. From the appropriate directory, type
spmarun r4hwtr <IP address> <community name>
The main Repeater Link/Seg Traps window, Figure 3-1, will appear.
Figure 3-1. The Repeater Link/Seg Traps Window
NOTES
The spmarun script invoked Þrst in the above command temporarily sets the environment
variables SPMA needs to operate; be sure to use this command any time you launch an
application from the command line. This script is automatically invoked when you launch
an application from the icon menu or from within the Hub View.
If you wish to change any Link/Seg Trap settings, be sure to use a community name with
at least Read/Write access. If you only wish to view current settings, a community name
with Read access will be sufÞcient.
If there is a hostname mapped to your SEHI100TXÕs IP address, you can use
<hostname> in place of <IP address> to launch this application. Please note, however,
that the hostname is not the same as the device name which can be assigned via Local
Management and/or SPMA; you cannot use the device name in place of the IP address.