Filter
Top Products
22
Figure 20b: Operating Instructions, SV9501 and SV9601 Gas Valves
Figure 19b: Top View of Honeywell SV9501 and SV9601 Gas Valves
"FOR YOUR SAFETY"
BEFORE OPERATING
result in a fire or explosion.
"TO TURN OFF GAS TO APPLIANCE"
the next step.
GAS
building.
fire department.
service technician. Force or attemped repair may
instructions.
gas valve; do not use any phone in your
Do not try to light any appliance.
If you cannot reach your gas supplier, call the
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
Do not touch any electric switch other than the
by hand, DO NOT try to repair it; call a qualified
"ON". Never use tools. If the switch does not move
WHAT TO DO IF YOU SMELL GAS:
3. Use only your hand to slide the gas control switch to
4. Do not use this appliance if any part has been
part of the control system and any gas control
technician to inspect the appliance. Replace any
under water. Immediately call a qualified service
that has been under water.
Follow step 2 in the section
9. Replace front door.
above on this label. If you do not smell gas, go to
8. Slide gas control switch to "ON".
INLET
and call your service technician or gas supplier.
instructions
OUTLET
because some gas is heavier than air and settles
explosion.
or death.
Follow these instructions exactly.
Force or attempted repair may result in a fire or
Can cause property damage, severe injury
Fire or Explosion Hazard.
WARNING
light the pilot by hand.
area for gas. Be sure to smell next to the floor
2. smell all around the appliance
which automatically lights the pilot. DO NOT try to
1. This appliance is equipped with an ignition device
label.
4. This appliance is equipped with an ignition device
7. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near floor. If you smell gas, STOP!
3. Turn off all electric power to the appliance.
that automatically lights the pilot. DO NOT try to
6. Slide gas control switch to "OFF".
5. Remove front door.
light the pilot by hand.
1. STOP! Read the safety information above on this
2. Set the thermostat to the lowest setting.
on the floor.
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTIONS
12. If the appliance does not operate, follow the
10. Turn on all electric power to the appliance.
11. Set the thermostat to desired setting.
IGNITION SYSTEM
CONTROL SWITCH
4. Slide gas control switch to "OFF". DO NOT force.
5. Replace front door.
1. Set the thermostat to the lowest setting.
3. Remove front door.
service is to be performed.
2. Turn off all electric power to the appliance if
TO TURN OFF GAS TO APPLIANCE
Honeywell
Honeywell