Filter
Top Products
59
CONTENTS
MACHINE
KNOWLEDGE
EMBROIDERING MAINTENANCE
ERROR
MESSAGE
TROUBLESHOOTING
PATTERNS
EMBROIDERING
USING A SMALL
FRAME
(OPTIONAL)
EMBROIDERING
USING A
EXTRA-SMALL
FRAME (OPTIONAL)
EMBROIDERING
USING A LARGE
FRAME
(OPTIONAL)
Warning message displays
This message is displayed when the bobbin winding shaft is at
the right side and the “START/STOP” button is pressed. This
message may be displayed after the display warns you to raise
the needle to the highest position.
ERROR MESSAGE
When the machine is not properly set and the “START/STOP” button is pressed, or a correction in your
operation is required, machine will not start and will instruct you with an alarm and error number on the
LCD.
This message is displayed when the “START/STOP” button is
pressed while the presser foot lever is raised.
This message is displayed when a pattern has not been
selected and the “START/STOP” button is pressed or “SET” is
touched.
This message is displayed when the machine senses that the
upper or lower thread has broken or no upper thread is
threaded or the bobbin runs out of the thread.
This message is displayed if the motor locks. This could be
caused by a tangled thread or embroidering with a bent needle.
This message is displayed when “RETRIEVE” is touched and
there is no pattern stored in that memory space.