Filter
Top Products
51
1. Set the stitch length using the scale on presser foot “A”.
Pull on the end of the button holder plate to expand it. The
finished size of the bar tack will be the space shown in the
illustration.
1 Scale on the presser foot
2 Button holder plate
3 0.5 cm (13/64")
4 Length of darning
5 Width [7 mm (9/32")]
* The maximum stitch length for darning is 3 cm (1-13/64").
2. Check the needle drop point and then lower the presser foot.
* After the presser foot lever has been lowered, ad-
just the presser foot so that there is no gap behind
the section that is shaded in the illustration at the
right. Otherwise, the size of the stitch will not be
correct. To adjust the presser foot, push the presser
foot towards the back of the machine as shown in
the figure at the left.
* Pass the thread underneath the presser foot.
4. While lightly holding the upper thread, start sewing.
* Before stopping, the machine will automatically sew a rein-
forcement stitch after the darning is finished.
3. Lower the buttonhole lever and position it behind the metal
bracket on the buttonhole foot.
1 Metal bracket on the buttonhole foot
DARNING
19:For medium fabric
20:For thick fabric
19
20
A
1
2
3
5
4
4
6
5
6
5
1
6
5
A