Filter
Top Products
13
1
2
3
BOBBIN WINDING / BOBBIN THREAD SETTING
Winding the bobbin and setting the bobbin thread
1. Connect the machine to the power supply and turn on the
main power.
2. Place the spool of thread on the spool pin. The thread end
should come from the bottom front of the spool. The spool cap
closest to the thread spool size should be used to hold the
spool securely on the spool pin.
1 Spool cap
2 Spool
3 Spool pin
* The spool cap should be pushed on as far as it will go.
Note
If using a fine thread such as cross wound thread, slightly sepa-
rate the spool cap (small) from the spool of thread before using it.
1 Cross wound thread
2 Spool cap (small)
3 Gap
CAUTION
Be sure to use the specified bobbin (part code 136492-151). Using a different bobbin may result in
injuries or damage.
1
2
3
1
5
2 4,9
7,8
3
6