Filter
Top Products
BES-941BC • BES-1241BC
161
Chapter 9 List of Error Messages
Code
E-21
E-22
E-23
E-24
E-25
E-26
E-27
E-28
E-29
E-2A
E-2B
E-2C
E-2D
E-2E
E-2F
E-31
E-32
E-33
E-34
E-36
E-38
E-39
E-3C
E-40
E-A1
E-A2
E-A3
E-A4
E-A5
E-A6
E-A7
Error Messages
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Area over
Remove unused presser foot, or
it may be damaged
Main(Z) motor lock
Main(Z) PCB temperature is too
high
Main(Z) motor voltage is too low
Main(Z) motor voltage is too
high
ERROR A5
ERROR A6
ERROR A7
Error
Hoop overhang(+X)
Hoop overhang(+Y)
Hoop overhang(+X, +Y)
Hoop overhang(-X)
Hoop overhang(+X, -X)
Hoop overhang(-X, +Y)
Hoop overhang(+X, -X, +Y)
Hoop overhang(-Y)
Hoop overhang(+X, -Y)
Hoop overhang(+Y, -Y)
Hoop overhang(+X, +Y, -Y)
Hoop overhang(-X, -Y)
Hoop overhang(+Y, -Y, -X)
Hoop overhang(+X, -X, -Y)
Hoop overhang(+X, -X, +Y, -Y)
Needle overhang(+X)
Needle overhang(+Y)
Needle overhang(+X, +Y)
Needle overhang(-X)
Needle overhang(-X, +Y)
Needle overhang(-Y)
Needle overhang(+X, -Y)
Needle overhang(-X, -Y)
The status of presser foot is issued as an alarm
when every second machine is used.
Spindle motor lock
Main PC board temperature too high
Spindle motor voltage too low
Spindle motor voltage too high
Spindle motor CPU error
Main shaft motor CPU communication com-
mand error
Main shaft motor CPU send/receive error
Measures
Pattern or the needle position is out of the embroidering area.
Reset the embroidering area on the panel or move the hoop to
the sewable position.
Reset the embroidering area on the panel or move the hoop to
a sewable position.
Thisected or when the bed is retreated (including when the power
is turned on). Remove the presser foot of the retreating head and
press the return key or turn on the F/B switch on the head to either
side. If every other head control is not selected or the bed is not
retreated, the bed sensor position may be faulty. Readjust it.
Press the
STOP
or turn on the F/B switch on the head to
either side. If it occurs frequently, the main shaft
mechanism is faulty.
This is not usually displayed.