Filter
Top Products
Chapter 6 Operation of Machine
BES-941BC • BES-1241BC
130
• If "area over" is displayed, press the check
switch. The hoop automatically moves
inside the embroidering area, where the
pattern is set, at the nearest position.
0.1mm
0.1mm
Embroidering area
(Example)
Embroidering
start position
6. Area Check
6-1 External Tracing
• If the check switch is pressed in other
cases than "area over", the rectangular
outline of the pattern is traced.
Note) The outline of pattern can be checked in rect-
angle or octagon by setting "Checking em-
broidery area" in "Enviromment 1".
6-2 Automatic Hoop Movement in Area
Note) After finishing the movement inside the area by this function, execute external tracing. Then, check that
the needle and the presser foot do not interfere with the hoop before starting embroidering.
Embroidering area
If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the area.
Enlarge the embroidering area on the operation panel.