Filter
Top Products
9-2 BE-1204B-BC • BE-1206B-BC
Chapter 9 Error code list
Code Error Messages Error Measures
E-00 ERROR 00 No error occurs.
E-01 ERROR 01
Either motor of main shaft, X- or Y-
axis, or lower shaft has locked.
E-02 Overtravel
Overtravel occurs during home
position detecting movement.
This is not usually displayed.
E-03
Stop SW was pressed
during home positioning
The stop switch is pressed during
home position detecting
movement.
Press the
or turn on the F/B switch on the
head to either side to restart the home position
detecting movement again.
E-04
Home position detection
is out of range
Home position detection out of
range
This is not usually displayed.
E-05
Needle stop position
error
Needle stop position error
Adjust the pulley stop position (100 degrees)
above the needle and press the
or turn on
the F/B switch on the head to either side.
E-06
Needle bar case
position error
Needle bar case position error
Adjust the position of needle bar case manually,
then press the
or turn ON the F/B switch on
the head to either side. If the same error occurs
again, the color change proper position sensor is
faulty.
E-07 Needle case lock Needle bar case lock
Press the
or turn on the F/B switch on the
head to either side. If the same error occurs
again, the color change mechanism is faulty.
E-08 ERROR 08
Stop switch or emergency switch
was pressed while the needle bar
case is traveling.
This is not usually displayed.
E-09
X-axis home position
error
X-axis home position detection
error
Turn the power off and on once. If the same
error occurs again, the X-axis mechanism is
faulty.
E-0A Thread breakage error Thread breaking error
After passing through the thread, press the
or turn on the F/B switch on the head to either
side.
E-0B ERROR 0B
Stop or emergency stop during
sewing
This is not usually displayed.
E-0C
Lower thread breakage
error
Lower thread broke during
embroidering.
After the replacement of the lower thread, press
the
or turn ON the F/B switch on the head to
either side.
E-0D ERROR 0D
The machine does not return to the
home position.
E-0E ERROR 0E Mending finish
This is not usually displayed.
E-0F
Needle bar No. reading
error
Failed in the reading of needle bar
No.
Press the
or turn ON the F/B switch on the
head to either side. If the same error occurs
again, the I/O CPU communication is faulty, or
the color change position sensor is faulty.
E-10
The beam sensor
turned ON
Abort by the beam sensor ON
Press the
or turn ON the F/B switch on the
head to either side.
E-11 X sensor reading error
Failed in the reading of X home
position sensor
Press the
or turn ON the F/B switch on the
head to either side. If the same error occurs
again, the I/O CPU communication is faulty.
E-12 Y sensor reading error
Failed in the reading of X home
position sensor
Press the
or turn ON the F/B switch on the
head to either side. If the same error occurs
again, the I/O CPU communication is faulty.