Filter
Top Products
BE-1204B-BC • BE-1206B-BC 6-9
Chapter 6 Operation of Machine
6. Area Check
6-1 External Tracing
W1278Q
If is pressed in other cases than "area over", the rectangular outline of the pattern is traced.
The outline of pattern can be checked in rectangle or octagon by setting "Checking embroidery area" in
"Environment 1".
6-2 Automatic Hoop Movement in Area
W1279Q
W1280Q
• If "area over" is displayed, press . The hoop automatically moves inside the embroidering
area, where the pattern is set, at the nearest position.
• After finishing the movement inside the area by this function, execute external tracing. Then,
check that the needle and the presser foot do not interfere with the hoop before starting
embroidering.
• If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the
area. Enlarge the embroidering area on the operation panel.
W1281Q
Embroidering
star position
Embroidering area
0.1 mm
0.1 mm
(Example)
Embroidering area