Filter
Top Products
ICP-CC488 | Installation Guide | 25.0 Programming Sheets EN | 102
Bosch Security Systems, Inc. | 12/08 | F01U089457-02
Transmission Format for Receiver 2
Location
073 Refer to page 50
1 Contact ID
2 4 + 2 express
3 FSK 300 baud
4 Domestic
5 Basic pager
6 Reserved
7 Reserved
8 Reserved
The Basic Pager option supports only
eight zones due to protocol limitations. If
you use more than eight zones, this option
is not recommended.
If you use the Zone 16, the 4 + 2 Express
and FSK 300 Baud formats are not
recommended because Zone 16 will be
assigned as "0" and some receivers will
not support this zone.
Subscriber ID Number For Receiver 2
Location
074 to 079 Refer to page 50
Default
0 0 0 0 0 0
Dialing Format
Location
080 Refer to page 50
1 Australian DTMF (5 digits/sec)
2 Australian decadic
3 Alternate DTMF and Australian decadic
4 International DTMF
5 Reversed decadic
6 Alternate DTMF and reversed decadic
Reserved
Location
081 to 112
Telco Arming Sequence
Location
113 to 142 Refer to page 50
Default
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Telco Disarming Sequence
Location
143 to 158 Refer to page 51
Default
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Callback Telephone Number
Location
159 to 174 Refer to page 51
Default
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Ring Count
Location
175 Refer to page 51
Default
8
0 Panel will not answer
1 to 13 Number of rings until panel answers
14 Answering machine bypass 2
15 Answering machine bypass 1
Telephone Line Fault Options
Location
176 Refer to page 52
Default
0
1 Display FAULT indicator if telephone line fails
2
Sound alarm when system is armed if telephone
line fails
4
Sound alarm when system is disarmed if
telephone line fails
8 Reserved
Dialer Options 1
Location
177 Refer to page 52
1 Dialer reporting functions allowed
2 Remote arming by telephone
4 Answering machine bypass only when armed
8
Use Bell 103 for FSK format (disabled – CCITT
v21)
Dialer Options 2
Location
178 Refer to page 53
Default
0
1 Open/Close Reports only after alarm
2 Open/Close Reports in STAY Mode allowed
4 Delay siren until transmission complete
8 Extend wait for handshake from 30 sec to 60 sec
Dialer Options 3
Location
179 Refer to page 53
Default
2
1 Set DTMF dialing pulses to 1 digit/sec
2 Lockout telephone line fail alarm
4 Change decadic dialing to 60/40
8 Reserved
Alarm Link Options
Location
180 Refer to page 41
1 Upload/download allowed
2
Callback phone number required for
upload/download
4 Exit upload/download connection on alarm
8 Reserved