Filter
Top Products
26
Bypass a Point
I have this feature.
I do not have this feature.
This feature requires a passcode.
The keypad makes it easy for you to have complete control of your security
system. With Command 0 you can bypass points you do not want included in the
system. You can bypass points when an area is disarmed. Bypassing a point
reduces the level of security and should be used with discretion. Points remain
bypassed until you unbypass them (refer to Unbypass a Point on page 27) or some
points can return when the area is disarmed.
COMMAND 0
To use Bypass a Point:
1. Ensure your security system is disarmed.
2. Press the [COMMAND] bar. The Command mode indicator light
comes on.
3. Press the [0] key. The system is now in the Bypass mode. (Some
points are set by your alarm company so they cannot be
bypassed).
4. To bypass a point, press the key that corresponds with the
number of that point, and then press the [ENT] key. The point
status light corresponding to the bypassed point flashes,
indicating the point is bypassed.