Filter
Top Products
12
Turn On the Perimeter With No Delays
I have this feature.
I do not have this feature.
This feature requires a passcode.
Command 2 is used to arm only the perimeter of your building, leaving the
interior of the building disarmed. This command allows no exit or entry delay
time through the perimeter, including the designated delay door. Enter your
personal passcode, plus [ENT], to cancel Command 2. Remember, there are no
entry or exit delays when you use this function. You must disarm (turn off) the
system to enter or exit the premises.
Application
This arming command is useful in residential systems at night when everyone is
home and ready to retire for the evening.
In commercial installations, this arming command is useful when you are
working late and you want the perimeter of the building armed until you are
ready to leave.
COMMAND 2
Arming with COMMAND 2:
1. Ensure all perimeter points are secure. Interior points are not
armed with this command, and can remain faulted while arming
with Command 2. Perimeter point status lights should be off. If
not, refer to Force Arming the System on page 29.
2. Press the [COMMAND] bar. The Command mode indicator light
comes on
3. Press the [2] key. The PERIMETER and INSTANT indicator lights
come on, showing the perimeter points are armed without entry/exit
delay time.
4. To disarm your security system or cancel Command 2, enter your
personal passcode and press [ENT] before the delay time expires.