Filter
Top Products
17
Walk Test
I have this feature.
I do not have this feature.
This feature requires a passcode.
Use this function to test keypads, detection devices, and sounders (both interior
and exterior) to be certain they function properly. You can review untested points
at your keypad to help pinpoint any problems.
You cannot arm your system while in the Walk Test Mode, and no Alarm Reports
are sent to your security company unless a 24-hour point is activated (such as fire
or panic).
Note: The AC is disabled for 4 minutes to test the system’s battery power. If the
battery cannot maintain the system for the 4 minutes period, the keypad
beomes unresponisive. If this happens, contact your security company. At
the end of the 4 minutes period, AC is returns to the system and the control
panel restores.
To test individual detection devices, simply activate sensors and open protected
doors and windows one at a time. As each detection device is faulted, the keypad
emits a brief tone and the display indicates the point is tested. This verifies that
each detection device is working properly.
COMMAND 4 4
To use Walk Test:
1. Ensure your security system is idle.
2. Press the [COMMAND] bar. The Command mode indicator light
comes on.
3. Press the [4] key, and then the [4] key again. Audible devices (both
interior and exterior) sound the burglary bell.
4. After silencing the audible devices, you can test detection devices.
Open a door or window or activate a motion sensor. Each time a
detection device is tested, the keypad beeps for 2 seconds. The
keypad display panel indicates the point you faulted verifying that
the detection device is working properly.
5. To end the Walk Test, press any numeric key on the keypad. If no
activity occurs on the system for 20 minutes, the Walk Test ends
automatically.