Filter
Top Products
15
Send Report
I have this feature as Command 41.
I have this feature as Command 42.
I do not have this feature.
This feature requires a passcode.
This function tests the communication link between your security system and
your security company. It is an important part of maintaining a high level of
security for your property.
Two types of Test Reports are sent. The first type (Command 41) simply tests the
communication of security messages to your security company. The second type
is a Status Report (Command 42), which sends the current condition of your
system in addition to testing the communication link to your security company.
COMMAND 4 1 & 4 2
To use COMMAND 4 1 or COMMAND 4 2:
1. Always call your security company before sending a Test Report.
2. Ensure your security system is disarmed.
3. Press the [COMMAND] bar. The Command mode indicator light
comes on.
4. Press the [4] key, and then press the [1] key, or press the [4] key
and then the [2] key for COMMAND 42.
5. After the report is received at your security company, the keypad
emits a beep tone for 2 seconds to confirm the test signal was
properly transmitted and received.