Filter
Top Products
20
Personal Passcode Change
I have this feature.
I do not have this feature.
This feature requires a passcode.
Your security system conveniently allows you to change your personal passcode
whenever you need to without the services of your alarm technician. It is
recommended that you write down both your old and new passcodes before you
begin.
Before you begin:
• Care should be given when entering a passcode containing the same
digits in consecutive positions within the new passcode (such as “3”
in 33467). When entering this type of passcode, it is easy to make
mistakes.
• The passcode is from three to six digits in length.
• To avoid conflicting with other passcodes and duress codes, your
system does not let you change to passcodes that are within plus or
minus two of an existing passcode. For example, if 1234 were an
existing code, your system would not let you change your code to
1232, 1233,1235, or 1236.
COMMAND 5 5
To change your personal passcode:
1. Ensure your security system is idle.
2. Press the [COMMAND] bar. The Command mode indicator light
comes on.
3. Press the [5] key and then the [5] key again. Your security system is
now in the Passcode Change Mode.
4. Enter the passcode you wish to change and press the [ENT] key.
5. Enter the new passcode and press the [ENT] key.
6. Enter the new passcode again and press the [ENT] key.
7. Test the new passcode by using it to arm and disarm the system.
Do not use any of the keypad arming commands to arm the
system until you are certain that the new passcode is working.